3000w water low fog machine water based Dual Output hazer smoke machine

Product specification

3000W Low Fog Machine (LCD+DMX+Remote)  3000W水雾机，双管带遥控

Power: 3000W

Voltage:AC110-220V  50/60Hz　

AC220V-240V 50/60HZ

Fuse: 10A/250V

Pre-heating time:8 minutes

Smoke output:4000cust/min

Capacity of oil tank:1.0L

Oil consumption ate:5min/L

DMX512/Controller:support/LCD

Wireless controller:optional                                                     

Packing:  91*40*48cm (with flight case)

G.W. 43KG

Can cover 70 square meters

Product advantages

1.With automatic pigging function, providing a heating tube of self-cleaning and prolong the life

2.The fuel consumption is very low, with a 1.3-liter drums, at 100% of full output mode, it can continuously work

3.A smart power saving mode automatically starts heating when the DMX is connected. The DMX signal stops and the machine automatically starts the piggyback process and then goes into Sleep mode.

4.The fan can be 20% to 100% of the output adjusted

5.Using air pressure pump technology to produce very dry smoke

6.Use waterborne special water fog oil, and clean water, very environmental protection

7.Short heating time, just 50 seconds

8.Very save smoke, 2 litres of water fog oil for 30 minutes

9.Smoke volume, never float up, even if someone stirs the smoke does not drift upwards

10.Ultra low fuel consumption, more energy saving and environmental protection

11.0-100 precision adjustment of smoke output

Precautions for the use of stage fog machines

The general stage fog machine is to spray the smoke oil containing the chemical components that can quickly vaporize after being heated at high temperature, and quickly pass through the high temperature heating tube to form white gaseous smoke. The crystals produced by the chemical components contained in the oil fume during the atomization process are easy to block the smoke pump and cause failure. The blocked smoke pump can only be replaced, which is inconvenient to maintain and high cost. In actual use, the chemical components in the smoke can also corrode stage equipment, pollute the environment, and cause damage to the health of performers.

The dry ice fog machine uses the principle of solid dry ice at -78°C to generate a large amount of white smoke when heated and vaporized at room temperature, providing a smoke effect for the stage. At present, low-power dry ice machines below 3kW are used in China, which are suitable for medium and small stages, but cannot be used for large stages.High-power dry ice machines have large smoke volume, fast smoke output, and can quickly cover the stage, as well as the advantages of environmental protection, which have been widely used in developed countries.

As a stage fog machine that is frequently used in stage equipment, because of its high power consumption and a key component - a heater, the maximum temperature can reach more than 300 degrees. Therefore, in the process of use, if it is improperly operated or not paid attention to maintenance, it will damage the machine and shorten the service life of the fog machine if it is small. The following is a detailed explanation of the operation steps, maintenance and precautions of the stage fog machine:

Operation steps of stage fog machine

1. Before turning on the power, check whether the smoke oil is added to the oil barrel of the fog machine.

2. Carefully check that the power supply voltage is consistent with the rated voltage of the fog machine.

3. The power supply should be connected to a power supply with a ground wire.

4. Connect different controllers (according to different types of fog machines, the control methods are divided into: 512 console control, wired control, wireless remote control, multiple control), which can realize different control functions.

5. Turn on the power switch (the power switch indicator light is on), the hood is in working state.

6. When the heating process is completed, the indicator light is on, and the controller switch is turned on to realize smoke spraying. (When the fog machine works for the first time, the smoke may be small or a small amount of water vapor may be ejected, which is normal.)

Precautions

1. The fog machine must be placed in a ventilated place and cannot be used in a hole, otherwise the temperature of the fog machine will be too high, the temperature control insurance will be disconnected, and the fog machine will not be heated.

2. The fog machine can be placed flat on the ground or installed at a high place parallel to the ground, but it cannot be installed at an angle. The fog machine should be kept at least 30CM above and below the surrounding area, which is conducive to the heat dissipation of the fog machine.

3. It should be installed in a place that children can't touch, away from flames and flammable and explosive materials, and 40CM away from the nozzle to prevent burns.

4. It is normal for all fog machines to emit a small amount of smoke (some even have a slight burnt smell) during the heating process.

FAQ

Q1.What is your delivery time?

A:3-5days for sample or small batch orders, 15-30days for mass production

Q2.What is the payment method?

A:T/T,Paypal,WU,Ali Pay.

Q3.How do you guarantee the quality of your products?

A:All Marslite products 100% full test 24hours before goods delivery.

Q4.Are you a factory or a trading company?

A:Manufacturer, with about 100 person in factory.

Q5.Where is your factory?

A:No 195, sandong Road,Huadu Distric ,Guangzhou City, China, very near the Guangzhou Baiyun Airport.

Q6.How long is the product warranty?

A:2 Years Warranty 

Q7.Does your packaging ensure product safety?

A:Marslite will do Drop testing for package to make sure all products is well packed.

Q8.How is your after-sales service?

A:We will give you spare parts and technical support to help you fix the light.